A Guide to TracVision R5/R4
4-6
2. If you are using HyperTerminal, open it and
establish the following settings:
• Bits per second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
If you are using the KVH Flash Update Wizard,
double-click the "KVH Flash Update Wizard"
shortcut on your computer's desktop to start the
wizard. You do not need to flash the antenna to view
diagnostic readouts; you will simply view the data in
the "TracVision Antenna Comms" window.
3. Apply power to the TracVision R5/R4 system and
allow the system to complete full initialization.
Observe the data scrolling on the PC display to
identify any system problems detected. If no data
is seen, recheck your connections and setup.