KVH Industries TracVision R5 Owner's Manual page 42

Using Your TracVision R5/R4
European Services
When the TracVision R5/R4 system and the receiver have
matching configurations, switching from one satellite to the other
is as easy as changing the channel using the remote control.
TracVision R5/R4 will automatically switch from Satellite A to B
and back again as necessary to receive your selected channel.
DIRECTV
DIRECTV subscribers in certain regions of the United States will
require a DSS Plus receiver to receive broadcasts from multiple
satellites. If connected to the antenna's RF1 connector, the DSS
Plus receiver allows you to switch satellites using the remote
control. If you are a DIRECTV subscriber, but do not have a DSS
Plus receiver, or you are using a multiswitch, use the optional
TV/SAT Switch (see Section 3.2.1, "Using the TV/SAT Switch to
Switch Between Satellites" on page 3-4).
ExpressVu
ExpressVu subscribers need to use the optional TV/SAT Switch
to switch between satellties (see Section 3.2.1, "Using the TV/SAT
Switch to Switch Between Satellites" on page 3-4).
DISH Network
DISH Network subscribers will need to configure the TracVision
R5/R4 system to use DISH 500 mode (see Section 3.2.2, "DISH
500 Mode" on page 3-6), which allows automatic switching
between the 119 and 110 satellites. Or you can manually switch
satellites using the optional TV/SAT Switch (see Section 3.2.1,
"Using the TV/SAT Switch to Switch Between Satellites" on page 3-4).
54-0157 Rev. J
3-3