Changing Channels And Switching Between Satellites - KVH Industries TracVision R5 Owner's Manual

A Guide to TracVision R5/R4
The satellite configuration on
your receiver must match the
satellite setting on the TracVision
R5/R4 system.
Satellite A on the TracVision R5/R4
must be the same satellite as
Receiver Alternative 1 (or A, based
on your receiver) and must be
assigned the Receiver DiSEqC 1
setting.*
Satellite B on the TracVision R5/R4
must be the same satellite as
Receiver Alternative 2 (or B, based
on your receiver) and must be
assigned the receiver DiSEqC 2
setting.*
Refer to your receiver's User's
Manual for complete instructions for
your receiver.
* DiSEqC applies to European systems only
3-2
3. Turn on the antenna using the switchplate (see
Figure 3-2).
Figure 3-2 Turning on the TracVision R5/R4
ntenna
On/Off
Switch
4. (TracVision R5 only) If the vehicle is moving, avoid
turning the vehicle for 60 seconds after turning on
the antenna to allow the antenna gyro to initialize
properly.
3.2 Changing Channels and
Switching Between Satellites
During installation, your system should have been set to the
satellite pair of your choice and the system should have
downloaded the appropriate channel guides. You must also have
a properly configured receiver (if this has not been done, refer to
your receiver's User's Manual for instructions).
Your TracVision system is programmed to track either of two
satellites, stored in memory as Satellite A and Satellite B. To select
between these two satellites, you can use the receiver remote
control or the optional TV/SAT Switch.
If you have three or more receiver/TV pairs installed using an
active multiswitch, you will need the TV/SAT Switch to switch
between the two satellites.