2.3.1 Connecting the Antenna Data/Power
Cable
1. Connect one end of the antenna data/power cable
to the antenna's data/power connector and lock in
place (see Figure 2-10).
Figure 2-10 Antenna Data/Power Connector
2. Route the other end of the data/power cable down
through the cable access hole in the vehicle's roof
and out through the switchplate panel cutout.
3. Connect the data/power cable to the switchplate's
data/power connector and lock in place (see
Figure 2-11).
Figure 2-11 Switchplate Data/Power Connector
54-0157 Rev. J
Data/Power
Data/Power
Installation
2-9