KVH Industries TracVision R5 Owner's Manual page 18

12. Cut the tie-wraps holding the antenna unit to the
forward shipping restraint (see Figure 2-7).
Figure 2-7 Forward Shipping Restraint
tie-wraps used
to secure LNB arm
Shipping Restraint
13. Remove the nuts and washers securing the
shipping restraints to the baseplate (see
Figure 2-8).
Figure 2-8 TracVision R5/R4 Shipping Restraints (Top View)
Rotating Plate
Shipping Restraint
Rotating Plate
Shipping Restraint
14. Remove the shipping restraints and replace the
nuts and washers into their original positions. All
nuts and washers removed in Step 13 must be
reinstalled. These nuts and washers secure the
baseplate to the mounting plates.
15. Place the radome onto the baseplate (labels facing
the sides of the vehicle) and secure in place using
the eight pan head screws and flat washers
removed in Step 10.
16. Drill the cable access hole (marked in Step 4) in the
vehicle's roof.
54-0157 Rev. J
Shipping Restraint
Nuts and Washers
Forward Shipping
Restraint for
LNB Bracket
Save the shipping restraints,
washers, and nuts in case the
antenna unit needs to be removed
and shipped to another location.
Four 1 ⁄ ˝ x 5 ⁄ ˝ hex head screws have
4 8
been provided in the kitpack for
shipping as the bolts used to hold
the shipping restraints during initial
shipping are integral parts of the
mounting plates.
Installation
2-7