KVH Industries TracVision R5 Owner's Manual page 46

Kvh industries satellitetelevision owner's manual tracvision r5, tracvision r4
Hide thumbs Also See for TracVision R5:
Table of Contents

Advertisement

6. Using the remote control's arrow buttons,
highlight "Check Switch" then press the Select
button.
7. Highlight "Test" then press Select.
8. Wait a minimum of 15 minutes for the Check
Switch function to complete and for the antenna to
restart and configure itself for DISH 500 mode.
If the Check Switch function fails (the receiver locks
up), disconnect power from the receiver, restart the
antenna, then restore power to the receiver and try the
Check Switch function again.
9. Run the Check Switch function a second time. This
allows the receiver to configure itself for automatic
satellite switching.
10. Wait until the Check Switch function is complete
(it will take a couple minutes).
11. Ensure that the TV display matches Figure 3-5:
Figure 3-5 Check Switch Screen
Installed Switch: SW42
Input:
Satellite:
Polarity:
Status:
This indicates that the receiver is configured
properly. If this information is not displayed
exactly as shown above, try running the Check
Switch function again.
12. Exit the menu and allow the receiver to download
the program guide.
13. Once the program guide has loaded, you can start
enjoying satellite TV. The antenna will now switch
between satellites automatically as you change
channels using the receiver's remote control.
54-0157 Rev. J
1
1
2
119
119
110
Odd
Even
Odd
Even
Satellite reception verified
2
110
Using Your TracVision R5/R4
3-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tracvision r4

Table of Contents