Ftp Server Configuration Example - HP 5800 Series Configuration Manual

To configure authentication and authorization for FTP server:
Step
1. Enter system view.
2. Create a local user
and enter its view.
3. Assign a password
to the user.
4. Assign the FTP
service to the user.
5. Configure user
properties.

FTP server configuration example

Network requirements
As shown in
•
1.2.1.1/16 and 1.1.1.1/16 respectively. Device and PC are reachable to each other.
PC keeps the updated boot file of the device. Use FTP to upgrade the device and back up the
•
configuration file.
• Set the username to ftp and the password to pwd for the FTP client to log in to the FTP server.
Figure 15 Upgrading using the FTP server
Command
system-view
local-user user-name
password { simple |
cipher } password
service-type ftp
authorization-attribute
{ acl acl-number |
callback-number
callback-number |
idle-cut minute | level
level | user-profile
profile-name | user-role
security-audit | vlan
vlan-id | work-directory
directory-name } *
Figure 15, use Device as an FTP server, and the PC as the FTP client. Their IP addresses are
Remarks
—
Required.
No local user exists by default, and the system does not
support FTP anonymous user access.
For more information about local-user, see Security
Command Reference.
Required.
For more information about password, see Security
Command Reference.
Required.
By default, the system does not support anonymous FTP
access, and does not assign any service. If the FTP
service is assigned, the root directory of the switch is
used by default.
For more information about service-type ftp, see
Security Command Reference.
Optional.
By default, the FTP/SFTP users can access the root
directory of the switch, and the user level is 0. Change
the default configuration by using this command.
For more information about authorization-attribute, see
Security Command Reference.
94