Configuring Common Settings For Vty User Interfaces (Optional) - HP 6125G Configuration Manual

Step
9. Create a local user and enter
local user view.
10. Set a password.
11. Specify the command level of
the local user.
12. Specify Telnet service for the
local user.
13. Exit to system view.
14. Configure common settings for
VTY user interfaces.
The next time you attempt to Telnet to the CLI, you must provide the configured login username and
password, as shown in
provide the correct password to access the CLI. If the maximum number of login users has been reached,
your login attempt fails and the message "All user interfaces are used, please try later!" appears.
Figure 15 Scheme authentication interface for Telnet login

Configuring common settings for VTY user interfaces (optional)

You might be unable to access the CLI through a VTY user interface after configuring the auto-execute
command command on it. Before you configure the command and save the configuration, make sure you
can access the CLI through a different user interface.
To configure common settings for VTY user interfaces:
Command
local-user user-name
password { cipher | simple }
password
authorization-attribute level
level
service-type telnet
quit
See "Configuring common
settings for VTY user interfaces
(optional)."
Figure 15. If you are required to pass a second authentication, you must also
37
Remarks
By default, no local user exists.
By default, no password is set.
Optional.
By default, the command level is 0.
By default, no service type is
specified.
N/A
Optional.