Displaying And Maintaining The Tftp Client - HP 5800 Series Configuration Manual

To configure the TFTP client:
Step
1. Enter system view.
2. Use an ACL to control the device's
access to TFTP servers.
3. Configure the source address of
the TFTP client.
4. Return to user view.
5. Download or upload a file in an
IPv4 network.
6. Download or upload a file in an
IPv6 network.

Displaying and maintaining the TFTP client

Task
Display the configuration of the
TFTP client.
Command
system-view
tftp-server [ ipv6 ] acl
acl-number
tftp client source
{ interface interface-
type interface-number
| ip source-ip-
address }
quit
tftp server-address
{ get | put | sget }
source-filename
[ destination-filename
] [ vpn-instance
vpn-instance-name ]
[ source { interface
interface-type
interface-number | ip
source-ip-address } ]
tftp ipv6 tftp-ipv6-
server [ -i interface
-type interface-
number ] { get | put }
source-file
[ destination-file ]
[ vpn-instance
vpn-instance-name ]
Command
display tftp client configuration [ | { begin |
exclude | include } regular-expression ]
101
Remarks
—
Optional.
By default, no ACL is used to control the
device's access to TFTP servers.
Optional.
A device uses the source address
determined by the matched route to
communicate with the TFTP server by
default.
If no primary IP address is configured on the
source interface, no TFTP connection can be
established.
If you use ftp client source to first configure
the source interface and then the source IP
address of the packets of the TFTP client, the
new source IP address will overwrite the
current one, and vice versa.
—
Optional.
Available in user view.
Optional.
Available in user view.
Remarks
Available in any view.