Configuring Common Settings For Vty User Interfaces (Optional) - HP 5800 Series Configuration Manual

Figure 13 Configuration page

Configuring common settings for VTY user interfaces (optional)

CAUTION:
The auto-execute command command may disable you from configuring the system through the user
interface to which the command is applied. Use it with caution.
Before executing the auto-execute command command and saving the configuration (by using save). Be
sure you can access the device through VTY and AUX user interfaces so you can remove the configuration
when a problem occurs.
Step
1. Enter system view.
2. Enable display of copyright
information.
3. Create a VLAN interface and enter
VLAN interface view.
4. Specify an IP address for a VLAN
interface.
5. Return to system view.
6. Enter one or multiple VTY user
interface views.
Command Remarks
system-view —
Optional.
copyright-info
enable
Enabled by default.
Required.
interface vlan-
interface vlan-
If the VLAN interface already exists, the
interface-id
command enters the VLAN interface view.
Required.
ip address ip-
address { mask |
By default, no IP address is specified for a
mask-length }
VLAN interface.
quit —
user-interface vty
first-number —
[ last-number ]
44