Login Procedure - HP 5800 Series Configuration Manual

Login procedure

Set up a configuration environment as shown in
1.
Console port of the device to a modem respectively.
Figure 2 Set up a configuration terminal
Configuration on the administrator side
2.
The PC and the modem are correctly connected, the modem is connected to a telephone cable, and the
telephone number of the remote modem connected to the Console port of the remote switch is obtained.
NOTE:
On the device:
The baud rate of the Console port is lower than the transmission rate of the modem. Otherwise, packets
•
may be lost.
• The parity check mode, stop bits, and data bits of the Console port adopt the default settings.
Perform the following configurations on the modem that is directly connected to the device:
3.
AT&F
ATS0=1
AT&D
AT&K0
AT&R1
AT&S0
ATEQ1&W ----------------------- Disable the modem from response to commands and save the
configuration
To verify your configuration, enter AT&V to show the configuration results.
NOTE:
The configuration commands and the output for different modems may be different. For more information,
see the user guide of your modem.
Launch a terminal emulation utility (such as HyperTerminal in Windows XP/Windows 2000), create a
4.
new connection (the telephone number is the number of the modem connected to the device).
NOTE:
On Windows 2003 Server operating system, you must add the HyperTerminal program first, and then log
in to and manage the device as described in this document. On Windows 2008 Server, Windows 7,
Windows Vista, or some other operating system, you must obtain a third party terminal control program
first, and follow the user guide or online help of that program to log in to the device.
Dial the destination number on the PC to establish a connection with the device, as shown in
5.
through
----------------------- Restore the factory defaults
----------------------- Configure auto-answer on first ring
----------------------- Ignore data Terminal Ready signals
----------------------- Disable local flow control
----------------------- Ignore Data Flow Control signals
----------------------- Force DSR to remain on
Figure 5.
Figure 2: connect the serial port of the PC and the
52
Figure 3