Login Methods - HP 5800 Series Configuration Manual

Login methods

Log in to the switch by using the following methods.
Table 4 Login methods
Login method
CLI login
Web login
Default state
Logging in By default, log in to a device through the console port, the
through the authentication mode is None (no username or password required),
console port and the user privilege level is 3.
By default, you cannot log in to a device through Telnet. To do so, log
in to the device through the console port, and complete the following
configuration:
•
Enable the Telnet function.
Logging in •
Configure the IP address of the VLAN interface, and make sure that
through Telnet
your device and the Telnet client can reach each other (by default,
the device does not have an IP address.).
•
Configure the authentication mode of VTY login users (password
by default).
•
Configure the user privilege level of VTY login users (0 by default).
By default, you cannot log in to a device through SSH. To do so, log
in to the device through the console port, and complete the following
configuration:
•
Enable the SSH function and configure SSH attributes.
Logging in •
Configure the IP address of the VLAN interface, and make sure that
through SSH
your device and the SSH client can reach each other (by default,
your device does not have an IP address.).
•
Configure the authentication mode of VTY login users as scheme
(password by default).
•
Configure the user privilege level of VTY login users (0 by default).
Logging in By default, log in to a device through modems. The default user
through modems privilege level of modem login users is 3.
By default, you cannot log in to a device through web. To do so, log
in to the device through the console port, and complete the following
configuration:
•
Configure the IP address of the VLAN interface (by default, your
device does not have an IP address.).
•
Configure a username and password for web login (not configured
by default).
•
Configure the user privilege level for web login (not configured by
default).
•
Configure the Telnet service type for web login (not configured by
default).
22