Field Service Ver. 1.0 May 2008
11.8.8
SELECT TRAY
Function
• This function can be used to select which paper tray can be used to supply paper when
printing received documents or transmission reports. (A paper tray that cannot be used
Use
for supplying paper can also be specified.)
1. Select the tray.
TRAY1
NOTE
Setting/
• If Tray 3 is not installed, TRAY3 does not appear.
procedure
2. Select the [DISABLE] or [ENABLE].
• The default setting is ENABLE.
11.9 REPORTING
11.9.1
ACTIVITY REPORT
Function
• Every 60 transmissions/receptions, a report can be printed to show the results of the
transmissions/receptions. This function can be used to set whether the report is printed
Use
automatically when the 60th transmission/ reception is reached.
• The default setting is ON.
Setting/
procedure
11.9.2
TX RESULT REPORT
Function
• This function can be used to set whether the report showing the result of a transmission
is printed automatically after the transmission is finished.
Use
• The default setting is ON (ERROR).
Setting/
procedure
ON: Prints the report after each transmission.
ON (ERROR): Prints the report after a transmission only if an error occurred.
OFF: Does not print the report after each transmission, even if an error has occurred.
11.9.3
RX RESULT REPORT
Function
• This function can be used to set whether the report showing the result of a reception is
printed automatically after mailbox reception is finished.
(If regular reception is not finished normally, a report will always be printed, regardless
Use
of the selected setting.)
• The default setting is ON (ERROR).
Setting/
procedure
ON: Prints the report after each reception.
ON (ERROR): Prints the report after a reception only if an error occurred.
OFF: Does not print the report after each reception, even if an error has occurred.
TRAY2
DISABLE
"ON"
OFF
ON
"ON (ERROR)"
ON
"ON (ERROR)"
TRAY3
"ENABLE"
OFF
OFF
11. Utility mode
143