Table of Contents
Advertisement
3.5 Turning the Machine On/Off and the Initial Mode
3.5
Turning the Machine On/Off and the Initial Mode
Turning the Machine On/Off
To turn on the machine:
➜
Press the | (on) side of the Power
Switch.
To turn off the machine:
Press the 2 (off) side of the Power
➜
Switch.
Note
Do not turn off the machine while a print cycle is being performed, as a paper
misfeed will result. Before attempting to turn off the machine, always be sure
that the current print cycle has been completed.
Turning off the machine will initialize all settings except those for previously
programmed jobs and for the Utility mode.
Do not turn off the machine while it is scanning or sending or receiving data,
otherwise all scanned data or transmission data will be deleted.
The machine automatically enters the Energy Save mode 15 min after the last
operation is performed.
The time until the machine enters Energy Save mode can be specified from the
Utility mode. For details, refer to "Specifying the Setting for "ENERGY SAVE
MODE"" on page 7-6 in the chapter "Using the Utility Mode".
When the Machine is Turned On
When the machine is turned on, the [Start] key indicator lights up in orange to
indicate that the machine is ready to begin printing.
At this time, the machine can be set for the Auto Print Start function by loading a
document into the Auto Document Feeder or by placing a document on the Original
Glass, and pressing the [Start] key.
Pressing the [Start] key at this time will not immediately start the print cycle. You will
have to wait for less than 25 seconds (at an ambient temperature of 73.4°F).
Di1610fp
3
3-15
Advertisement
Table of Contents
