Disclaimer - Polar Electro M400 User Manual

This Class B digital apparatus complies with Canadian ICES-003, RSS-Gen and RSS-210.
Cet appareil numérique de la classe B est conforme à la norme NMB-003, CNR-Gen et CNR-210 du Canada.
USA
Polar Electro Oy has not approved any changes or modifications to this device by the user. Any changes or
modifi cations could void the user's authority to operate the equipment.
FCC regulatory information
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pur-
suant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular install-
ation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/ TV technician for help.
This product emits radio frequency energy, but the radiated output power of this device is far below the FCC
radio frequency exposure limits.
This equipment complies with FCC RF radiation exposure limits forth for an uncontrolled environment. Never-
theless, the device should be used in such a manner that the potential for human contact with the antenna dur-
ing normal operation is minimized.

DISCLAIMER

The material in this manual is for informational purposes only. The products it describes are subject to
l
change without prior notice, due to the manufacturer's continuous development program.
Polar Electro Inc./Polar Electro Oy makes no representations or warranties with respect to this manual
l
or with respect to the products described herein.
80