Mac Filtering - Tenda AC1200 User Manual


Filter Name: Specify a new filter name for identifying the incoming IP traffic.

IP Version: Select either IPv4.

Protocol: TCP/UDP, TCP, UDP and ICMP are available for your option.

Source IP address [/prefix length]: Enter the Internal IP address [/prefix length] to be filtered.

Source Port (port or port:port): Specify a port number or a range of ports used by PCs from external network to
access your internal network.

Destination IP address [/prefix length]: Specify the internal network IP address [/prefix length] to be accessed by
the specified PCs from external network.

Destination Port (port or port:port): Specify a port number or a range of ports used by PCs from external network
to access your internal network.

Click Apply/Save to save and activate the filter.

2.5.2 MAC Filtering

A bridge WAN service is needed to configure this service.
MAC Filtering is only effective on ATM PVCs configured in Bridge mode. FORWARDED means that all MAC layer
frames will be FORWARDED except those matching with any of the specified rules in the following table. BLOCKED
means that all MAC layer frames will be BLOCKED except those matching with any of the specified rules in the
following table.
Choose Add enter the following screen. (Note that changing from one policy to another of an interface will cause all
defined rules for that interface to be REMOVED AUTOMATICALLY! You will need to create new rules for the new
policy.)
Wireless AC1200 ADSL2+ Dual Band Modem Router
101