Switch Utility Commands - D-Link DES-1228 Reference Manual

The switch utility commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
download
config firmware
show firmware
information
show config
upload
enable autoconfig
disable autoconfig
show autoconfig
ping
config terminal _line
show terminal line
config configuration
config configuration trap
Each command is listed, in detail, in the following sections.
download
Purpose
Syntax
Description
Parameters
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[ firmware_fromTFTP <ipaddr> <path_filename 64> image_id <value 1-2> | cfg_fromTFTP
<ipaddr> <path_filename 64> {config_id <value 1-2> | increment} ]
image_id <int 1-2> [delete | boot_up]
[ current_config {[include | exclude | begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>}} {[include | exclude | begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>}} {[include | exclude | begin] <filter_string 80> {<filter_string 80>
{<filter_string 80>}}}}} | config_in_nvram <config_id 1-2> {[include | exclude | begin]
<filter_string 80> {<filter_string 80>{<filter_string 80>}} {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude | begin]
<filter_string 80>{<filter_string 80> {<filter_string 80>}}}}} | information ]
[ cfg_toTFTP <ipaddr> <path_filename 64> {config_id <value 1-2>} {[include | exclude |
begin] <filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}} {[include | exclude | begin]
<filter_string 80> {<filter_string 80> {<filter_string 80>}}}}} | log_toTFTP <ipaddr>
<path_filename 64>]
<ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
[default | <value 20-80>]
config_id <value 1-2> [ delete | boot_up | active ]
{save [enable|disable] | upload [enable|disable] | download [enable|disable]}(1)
Used to download and install new firmware or a Switch configuration file from a TFTP
server.
download [ firmware_fromTFTP <ipaddr> <path_filename 64> image_id <value 1-2>
|cfg_fromTFTP <ipaddr> <path_filename 64> {config_id <value 1-2> | increment} ]
This command is used to download a new firmware or a Switch configuration file from a
TFTP server.
firmware_fromTFTP − Download and install new firmware on the Switch from a TFTP
server.
cfg_fromTFTP − Download a switch configuration file from a TFTP server.
<ipaddr> − The IP address of the TFTP server.
<path_filename> − The DOS path and filename of the firmware or switch configuration file
on the TFTP server. For example, C:\1228.had.
S U
WITCH
54
9
C
TILITY OMMANDS