D-Link DES-1228 Reference Manual page 154

show dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To show the DHCP relay configuration:
DES-1228/ME:4#show dhcp_relay
Command: show dhcp_relay
DHCP/BOOTP Relay Status
DHCP/BOOTP Hops Count Limit
DHCP/BOOTP Relay Time Threshold : 0
DHCP Relay Agent Information Option 82 State
DHCP Relay Agent Information Option 82 Check
DHCP Relay Agent Information Option 82 Policy
DHCP Relay Agent Information Option 82 Remote ID : 00-19-5B-EF-78-B5
Interface Server 1
------------ ---------------
DES-1228/ME:4#
Example usage:
To show a single IP destination of the DHCP relay configuration:
DES-1228/ME:4#show dhcp_relay ipif System
Command: show dhcp_relay ipif System
Interface Server 1
--------- -----------
System 10.58.44.6
DES-1228/ME:4#
enable dhcp_relay
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable DHCP relay:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to display the current DHCP/BOOTP relay configuration.
show dhcp_relay {ipif [System]}
This command will display the current DHCP relay configuration for the Switch.
ipif System − The name of the IP interface for which to display the current DHCP relay
configuration.
None.
: Disabled
: 4
Server 2
---------------
Server 2
------------
Used to enable the DHCP/BOOTP relay function on the Switch.
enable dhcp_relay
This command is used to enable the DHCP/BOOTP relay function on the Switch.
None.
Only Administrator-level users can issue this command.
: Disabled
: Disabled
: Replace
Server 3
---------------
Server 3 Server 4
----------- --------------
149
Server 4
--------------