Dhcp Server Screen List - D-Link DES-1228 Reference Manual

The switch history commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config filter dhcp_server
config filter dhcp_server trap_log
config filter dhcp_server
illegal_server_log_suppress_duration
show filter dhcp_server
config filter dhcp_server
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure filtering on the DHCP Server:
DES-1228/ME:4#config filter dhcp_server add permit server_ip 10.90.90.10 ports a
ll
Command: config filter dhcp_server add permit server_ip 10.90.90.10 ports all
Success.
DES-1228/ME:4#
config filter dhcp_server trap_log
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[add permit server_ip <ipaddr> {client_mac <macaddr>} ports [<portlist>|all]|
delete permit server_ip <ipaddr> {client_mac <macaddr>} ports [<portlist>|all]
| ports [<portlist>|all] state [enable | disable]]
[enable| disable]
[1min | 5min | 30min]
This command is used to configure filtering on the DHCP Server.
config filter dhcp_server [add permit server_ip <ipaddr> {client_mac <macaddr>}
ports [<portlist>|all]| delete permit server_ip <ipaddr> {client_mac <macaddr>} ports
[<portlist>|all] | ports [<portlist>|all] state [enable | disable]]
This command is used to configure filtering on the DHCP Server.
add permit server_ip <ipaddr> – The user can add a permit server IP address here
delete permit server_ip <ipaddr> - The user can delete a permit server IP address here.
ports [<portlist>|all] – The user can add a defined port list here or select all ports.
client_mac <macaddr> - The user can enter the client MAC address in here.
state [enable | disable] – The user can enable or disable the state of this command here.
Only Administrator-level users can issue this command.
This command is used to configure filtering trap logs for the DHCP Server.
config filter dhcp_server trap_log [enable| disable]
This command is used to configure filtering trap logs for the DHCP Server.
[enable| disable] – The user can enable or disable the trap logs feature in this field.
Only Administrator-level users can issue this command.
DHCP S
ERVER
292
45
S L
CREEN IST