D-Link DES-1228 Reference Manual page 66

Example usage:
To stop the auto configuration function:
DES-1228/ME:4#disable autoconfig
Command: disable autoconfig
Success.
DES-1228/ME:4#
show autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To display the autoconfig status:
DES-1228/ME:4#show autoconfig
Command: show autoconfig
Autoconfig State:
DES-1228/ME:4#
ping
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Used to display the current autoconfig status of the Switch.
show autoconfig
This command will list the current status of the auto configuration function.
None.
None.
Disabled
Used to test the connectivity between network devices.
ping <ipaddr> {times <value 1-255>} {timeout <sec 1-99>}
The ping command sends Internet Control Message Protocol (ICMP) echo messages to a
remote IP address. The remote IP address will then "echo" or return the message. This is
used to confirm connectivity between the Switch and the remote device.
<ipaddr> − Specifies the IP address of the host.
times <value 1-255> − The number of individual ICMP echo messages to be sent. A value
of 0 will send an infinite ICMP echo messages. The maximum value is 255. The default is
0.
timeout <sec 1-99> − Defines the time-out period while waiting for a response from the
remote device. A value of 1 to 99 seconds can be specified. The default is 1 second
None.
61