D-Link DES-1228 Reference Manual page 258

Example usage
To change the packet transmission interval:
DES-1228/ME:4# config lldp message_tx_interval 30
Command: config lldp message_tx_interval 30
Success.
DES-1228/ME:4#
config lldp message_tx_hold_multiplier
Purpose
Syntax
Description
Parameters
Restrictions
Example usage
To change the multiplier value:
DES-1228/ME:4# config lldp message_tx_hold_multiplier 3
Command: config lldp message_tx_hold_multiplier 3
Success.
DES-1228/ME:4#
config lldp tx_delay
Purpose
Syntax
Description
Parameters
Restrictions
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
This command is used to configure the message hold multiplier.
config lldp message_tx_hold_multiplier < int 2 - 10 >
This parameter is a multiplier on the msgTxInterval that is used to compute the TTL value
of txTTL in an LLDPDU. TheTTL will be carried in the LLDPDU packet. The lifetime will be
the minimum of 65535 and (message_tx_interval * message_tx_hold_multiplier). At the
partner switch, when the time-to-Live for a given advertisement expires, the advertised
data is deleted from the neighbor switch's MIB.
message_tx_hold_multiplier − The range is from 2 to 10. The default setting 4.
Only Administrator-level users can issue this command.
Used to change the minimum time (delay-interval) of any LLDP port. It will delay
advertising successive LLDP advertisements due to a change in LLDP MIB content. The
tx_delay defines the minimum interval between the sending of LLDP messages due to
constant changes of MIB content.
config lldp tx_delay < sec 1–8192 >
The LLDP message_tx_interval (transmit interval) must be greater than or equal to (4 x
tx_delay interval).
tx_delay − The range is from 1 second to 8192 seconds. The default setting 2 seconds.
NOTE: txDelay should be less than or equal to 0.25 * msgTxInterval
Only Administrator-level users can issue this command.
253