D-Link DES-1228 Reference Manual page 60

download
Restrictions
Note: The TFTP server must be on the same IP subnet as the Switch
Example usage:
To download a configuration file:
DES-1228/ME:4#download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Command: download cfg_fromTFTP 10.48.74.121 c:\cfg\setting.txt
Connecting to server................... Done.
Download configuration................. Done.
DES-1228/ME:4#
DES-1228/ME:4##-------------------------------------------------------------------
DES-1228/ME:4##
DES-1228/ME:4##
DES-1228/ME:4##
DES-1228/ME:4## Copyright(C) 2009 D-Link Corporation. All rights reserved.
DES-1228/ME:4##-------------------------------------------------------------------
DES-1228/ME:4#
DES-1228/ME:4#
DES-1228/ME:4## BASIC
DES-1228/ME:4#
DES-1228/ME:4#config serial_port baud_rate 9600 auto_logout 10_minutes
Command: config serial_port baud_rate 9600 auto_logout 10_minutes
The download configuration command will initiate the loading of the various settings in the order listed in the configuration file.
When the file has been successfully loaded the message "End of configuration file for DES-1228/ME" appears followed by the
command prompt.
DES-1228/ME:4#disable authen_policy
Command: disable authen_policy
Success.
DES-1228/ME:4#
config firmware
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
image_id <int 1-2> − Specify the working section ID. The Switch can hold two firmware
versions for the user to select from, which are specified by section ID.
increment − Allows the download of a partial switch configuration file. This allows a file to
be downloaded that will change only the switch parameters explicitly stated in the
configuration file. All other switch parameters will remain unchanged.
Only Administrator-level users can issue this command.
DES-1228/ME Configuration
Firmware: Build 1.00.B04
55