D-Link DES-1228 Reference Manual page 182

create cpu access_profile
Restrictions
Example usage:
To create a CPU access profile:
DES-1228/ME:4# create cpu access_profile profile_id 1 ip vlan source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type code
Command: create cpu access_profile profile_id 1 ip vlan source_ip_mask 20.0.0.0
destination_ip_mask 10.0.0.0 dscp icmp type code
Success.
DES-1228/ME:4#
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
source_ip_mask <netmask> − Specifies an IP address mask for the source IP address.
destination_ip_mask <netmask> − Specifies an IP address mask for the destination IP
address.
dscp − Specifies that the Switch will examine the DiffServ Code Point (DSCP) field in each
frame's header.
icmp − Specifies that the Switch will examine the Internet Control Message Protocol
(ICMP) field in each frame's header.
type − Specifies that the Switch will examine each frame's ICMP Type field.
code − Specifies that the Switch will examine each frame's ICMP Code field.
igmp - Specifies that the Switch will examine each frame's Internet Group Management
Protocol (IGMP) field.
type – Specifies that the Switch will examine each frame's IGMP Type field.
tcp − Specifies that the Switch will examine each frames Transport Control Protocol (TCP)
field.
src_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a TCP port mask for the destination
port.
flag_mask [ all | {urg | ack | psh | rst | syn | fin}] – Enter the appropriate flag_mask
parameter. All incoming packets have TCP port numbers contained in them as the
forwarding criterion. These numbers have flag bits associated with them which are
parts of a packet that determine what to do with the packet. The user may deny
packets by denying certain flag bits within the packets. The user may choose
between all, urg (urgent), ack (acknowledgement), psh (push), rst (reset), syn
(synchronize) and fin (finish).
udp − Specifies that the switch will examine each frame's Universal Datagram Protocol
(UDP) field.
src_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the source port.
dst_port_mask <hex 0x0-0xffff> − Specifies a UDP port mask for the destination
port.
protocol_id_mask <hex 0x0-0xff> − Specifies that the Switch will examine each frame's
Protocol ID field using the hex form entered here.
user_define_mask <hex 0x0-0xffffffff> − Specifies that the rule applies to the IP protocol ID
and the mask options behind the IP header.
profile_id <value 1-3> − Enter an integer between 1 and 3 that is used to identify the CPU
access profile to be created with this command.
Only Administrator-level users can issue this command.
177