Basic Ip Commands - D-Link DES-1228 Reference Manual

The IP interface commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the
following table.
Command
config ipif
show ipif
enable autoconfig*
Each command is listed, in detail, in the following sections.
*See Switch Utility Commands for descriptions of all autoconfig commands.
config ipif
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IP interface System:
DES-1228/ME:4#config ipif System ipaddress 10.48.74.122/8
Command: config ipif System ipaddress 10.48.74.122/8
Success.
DES-1228/ME:4#
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
Parameters
[System] [{ ipaddress <network_address> | vlan <vlan_name 32> | state [enable|disable]} |
bootp | dhcp | dhcp_option12 [hostname <hostname 63> |clear_hostname | state
[enable|disable]]]
Used to configure the System IP interface.
config ipif [System] [{ ipaddress <network_address> | vlan <vlan_name 32> | state
[enable|disable]} | bootp | dhcp | dhcp_option12 [hostname <hostname 63>
|clear_hostname | state [enable|disable]]]
This command is used to configure the System IP interface on the Switch.
System − Enter System.
ipaddress <network_address> − IP address and netmask of the IP interface to be created.
Users can specify the address and mask information using the traditional format (for
example, 10.1.2.3/255.0.0.0 or in CIDR format 10.1.2.3/8).
<vlan_name 32> − The name of the VLAN corresponding to the System IP interface.
state [enable | disable] − Allows users to enable or disable the IP interface.
bootp − Allows the selection of the BOOTP protocol for the assignment of an IP address to
the Switch's System IP interface.
dhcp − Allows the selection of the DHCP protocol for the assignment of an IP address to
the Switch's System IP interface. If users are using the autoconfig feature, the Switch
becomes a DHCP client automatically so it is not necessary to change the ipif settings.
dhcp_option12 [hostname <hostname 63> − Allows users to specify the option12
hostname.
Only Administrator-level users can issue this command.
B
ASIC
131
18
IP C
OMMANDS