D-Link DES-1228 Reference Manual page 64

Note: The TFTP server must be on the same IP subnet as the Switch
Example usage:
To upload a configuration file:
DES-1228/ME:4#upload cfg_toTFTP 10.48.74.121 c:\cfg\log.txt
Command: upload cfg_toTFTP 10.48.74.121 c:\cfg\log.txt
Connecting to server................... Done.
Upload configuration...................Done.
DES-1228/ME:4#
enable autoconfig
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To enable auto configuration on the Switch:
DES-1228/ME:4#enable autoconfig
Command: enable autoconfig
Success.
DES-1228/ME:4#
When autoconfig is enabled and the Switch is rebooted, the normal login screen will appear for a few moments while the
autoconfig request (i.e. download configuration) is initiated. The console will then display the configuration parameters as they
are loaded from the configuration file specified in the DHCP or TFTP server. This is exactly the same as using a download
configuration command. After the entire Switch configuration is loaded, the Switch will automatically "logout" the server. The
configuration settings will be saved automatically and become the active configuration.
Upon booting up the autoconfig process is initiated, the console screen will appear similar to the example below. The
configuration settings will be loaded in normal order.
DES-1228/ME Layer 2 Metro Ethernet Switch CLI Reference Manual
This command is used to enable the Auto Configuration for this Switch
enable autoconfig
This command is used to enable the Auto Configuration for this Switch
None.
Only Administrator-level users can issue this command.
59