Using Ethernet Interface To Setup Ethernet Interface - Wasp WPL304 User Manual

WPL 304 User Manual

3.6.3 Using Ethernet interface to setup Ethernet interface

1. Connect the computer and the printer to the LAN.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicks on the
Note: This utility works with printer firmware V6.00 and later versions.
4. Select
address, subnet mask and gateway for the on board Ethernet.
5. Click the
6. Select the printer in the left side of listed printers, the correspondent IP address will
be shown in the right side
7. Click
The default IP address is obtained by DHCP. To change the setting to static IP
address, click
Ethernet as the interface then click on the
" "
Discover Device
" "
IP address/Printer Name
"
Change IP Address
" "
Static IP radio button then enter the IP address, subnet mask and
" "
button to explore the printers that exist on the network.
to configure the IP address obtained by DHCP or static.
22
icon.
Setup button to setup the IP
" "
field.
"