Loading Media In Peel-Off Mode (Option); Loading Media In Cutter Mode (Option) - Wasp WPL304 User Manual

WPL 304 User Manual

3.4.3 Loading Media in Peel-off Mode (Option)

Refer to section 3.4.1 to load the media.
1.
Feed the paper, printing side facing up, through the paper guide and pass over the
2.
platen.
Move the media guides to fit the label width by turning the guide adjuster knob.
3.
Use "Diagnostic Tool" to set the media sensor type and calibrate the selected sensor.
4.
(Start the "Diagnostic tool" - Select the "Printer Configuration" tab - Click the "Calibrate
Sensor" button) Please refer to the diagnostic utility quick start guide for more information.
Open the peel-off panel by pulling it out.
5.
Lead the media through the backing paper opening, beneath the peel-off roller.
6.
Push the peel-off panel back to the printer.
7.
Disengage the top cover support and close the top cover gently.
8.
Peeling will automatically start. Press the FEED button to test.
9.
Note:
Please calibrate the gap/black mark sensor when changing media.
•
This peel-off module is supported for the thermal/plain label only.
•
16