Wasp WPL304 User Manual page 33

WPL 304 User Manual
Self-test
Printer will print the printer configuration after
Self-test printout can be used to check if there is any dot damage on the heater element,
printer configurations and available memory space.
xxxxxxxxxxxxxxx
Self-test printout (with printer firmware V7.0 and later version)
gap/black mark sensor calibration.
Print head test pattern
Printer model name & Main board firmware version
Printed
mileage
Main board firmware checksum
Serial port
setting
Code page
Country code
Print speed
Print
darkness
Label size (width, height)
Gap size (vertical gap,
offset) Sensor sensitivity
File management information
Model name F/W
version
checksum
Printer S/N
WPL304 configuration file
System date System
time Printed mileage
(meter)
Cutting counter
29
Firmware