Unpacking And Setting Up The Scan Station; Installing The Power Cord; Installing The Network Cable; Attaching The Input Tray - Kodak SCAN STATION 100 User Manual

Unpacking and
setting up the Scan
Station

Installing the power cord

Installing the network cable

Attaching the input tray

A-61544 April 2006
Carefully unpack the Scan Station 100 and place it on a clean, dry and
level surface. Locate and attach the power cord and network cable.
Then attach the input and output trays. Make sure the Scan Station
cover is closed.
1. Select the appropriate AC power cord.
2. Plug one end of the power cord into the Scan Station.
3. Plug the other end of the power cord into the wall outlet.
1. Select a (customer provided) 10/100Base-T drop cable.
2. Plug one end of the drop cable into the network port of the Scan
Station.
3. Plug the other end of the network cable into the network drop's wall
outlet.
1. Locate the input tray slots on the Scan Station.
2. Align the input tray pins with the slots.
3. Push down on the input tray until it snaps into place.
1-13