Table of Contents
Advertisement
Reference
Information
This section provides procedures for mounting the DTP DVI 330 Tx/Rx transmitter and
receiver and disconnecting the ground between them.
•
•
Mounting the Transmitter or Receiver
ATTENTION:
The 1-inch high, quarter rack width DTP DVI 330 transmitter or receiver can be placed on
a table, mounted in a rack, or mounted under a desk or table. The receiver can also be
mounted on a projector bracket.
Tabletop Use
Affix the included rubber feet to the bottom of the unit and place it in any convenient
location.
Mounting kits
Mount the unit using any optional compatible mounting kit listed on the Extron website
(www.extron.com), in accordance with the directions included with the kit. For rack
mounting, see
Mounting the Transmitter or Receiver
Disconnecting the Ground
Installation and service must be performed by authorized personnel only.
•
•
L'installation et l'entretien doivent être effectués uniquement par un technicien
qualifié.
•
Avoid ground potential differences between the transmitter and receiver
installation sites, which can lead to equipment damage or a missing or unstable
picture.
Évitez les différences de potentiel de mise à la terre entre les sites d'installation
•
d'émetteur et de récepteur de commutation, qui pourraient endommager
l'équipement ou rendre l'image invisible ou irrégulière.
If a potential difference cannot be avoided, remove the ground connection
•
between the units and locally power both units (see
on page 12). In this configuration, the DTP DVI 330 cannot extend analog
audio and each unit requires a local power supply.
•
Si une différence de potentiel ne peut être évitée, enlevez la connexion de mise à
la terre entre les unités et alimentez les deux unités localement (voir Déconnecter
la mise à la terre page 12).
UL Rack-Mounting Guidelines
DTP DVI 4K 330 Transmitter and Receiver • Reference Information
Disconnecting the Ground
on the next page.
10
Advertisement
Table of Contents
