Range Installation - Jenn-Air JDS8850AAB Service Manual

Installation Instructions (Model JDS9860A**)
8. Install the 6 (15.24 cm) elbow of the blower housing
and secure with duct tape. The open end of the elbow
should be pointed to the left. Attach the 6 (15.24 cm)
flex duct (provided with the range) to the elbow and to
the range. Note: For right side venting, the 6 (15.24
cm) diameter flex duct may be cut in half and used in
order to make assembly easier.

RANGE INSTALLATION

CONNECTING THE DOWNDRAFT BLOWER
TO ELECTRICAL
(Figure 18)
S Connect the blower power cord to the blower motor
housing.
Figure 18
INSTALLING THE FLEX DUCT TO BLOWER
S Use one of the duct clamps provided. Using a screw
driver, tighten duct clamp to secure the flex duct to the
inlet of the blower. (See figure 19).
Figure 19
©2005 Maytag Services
INSTALLING THE BLOWER
NOTE:
Install the blower prior to installing the
range.
S Refer to your duct plan. It may be easier to attach part
of the ducting to the blower before it is installed.
S Position the blower and attach to the floor with at least
2 screws.
S Apply duct tape to blower exhaust duct joint. (See
figure 12).
INSTALLING THE RANGE
In The Commonwealth Of Massachusetts
This product must be installed by a licensed plumber or
gas fitter when installed within the Commonwealth of
Massachusetts.
A "T" handle type manual gas valve must be installed in
the gas supply line to this appliance.
A flexible gas connector, when used, must not exceed a
length of three (3) feet / 36 inches.
S Align the range to its designated location and slide
back into position. Make sure that the rear leveling leg
is fully inserted and secured by the anti-tip bracket.
S Attach the other end of the flex duct to the plenum of
the range using the second duct clamp. Tighten duct
clamp to secure it to the plenum.
CHECK FOR OPERATION
S Install the air filter. As you face the range, the top of
the filter should rest against the left side of the vent
opening. DO NOT OPERATE THE SYSTEM
WITHOUT THE FILTER.
S Install the air grille over the vent opening.
S Be sure to remove all packing materials the oven from
unit prior to applying power.
S Switch electrical circuit breaker to the ON position.
S Consult USE and CARE MANUAL for proper operation.
16026016 A – 15