Maintop Assembly; Control Panel; Electronic Control; Bottom Access Panel - Jenn-Air JDS8850AAB Service Manual

Disassembly Procedures

Maintop Assembly

1. Remove power from unit.
2. Remove range from installation position, see
"Removing and Replacing Range" procedure.
3. Remove air grill, filter, grill grates, aeration pan and
cartridges (select models).
4. Remove screws from plenum area at front of
opening.
5. Remove front side trim, see "Remove Front Side
Trim" procedure.
6. Remove cartridge receptacles and grill pans (select
models).
7. Remove screws around perimeter of unit securing
main top to chassis.
8. Label and disconnect wiring to elements (select
models).
9. Remove screws securing element mounting brackets
to main top assembly (select models).
10.Gently remove elements from mounting brackets to
prevent damage to glass top (select models).
11. Reverse procedure to reinstall maintop assembly.

Control Panel

1. Remove power from unit.
2. Remove burner switch control knobs.
3. Open oven door and remove screws securing control
panel.
4. Remove screws located on the right and left sides of
the control panel.
5. Grasp control panel on the far left and right sides and
gently pull the control panel out and down.
NOTE: Gently pull control panel out and down.
6. Remove infinite switch control knobs, infinite
switches, indicator lights, rocker switches, and
electronic control/clock (as necessary) and transfer to
the new control panel.
7. Reverse procedure to reinstall control panel.

Electronic Control

1. Remove control panel, see "Control Panel"
procedure, steps 1 through 5.
2. Remove screws securing electronic control bracket to
control panel.
3. Label and disconnect terminal wiring from electronic
control.
4. Reverse procedure to reinstall electronic control.
©2005 Maytag Services
To avoid risk of electrical shock, personal injury or
death; disconnect power to unit before servicing.

Bottom Access Panel

1. Grasp top of bottom access panel and gently pull
down and out.
2. Reverse procedure to reinstall bottom access panel.

Indicator Lights

1. Remove control panel, see "Control Panel" procedure
for removal.
2. Label and disconnect wires from indicator light.
3. Squeeze the two tabs on the indicator light body and
gently pull to release from control panel.
4. Reverse procedure to reinstall indicator light.
Broil Element
Bake
Element
16026016
Electronic
Control
Control
Panel
Oven Sensor
Cooling
Fan
Transformer
Meat
Probe
25