Jenn-Air JDS8850AAB Service Manual page 62

LP Conversion Instructions
SURFACE BURNER HEADS
BURNER BASES
S
The surface burner heads are removable. The cap
portion of the head is porcelain and the port area is
aluminum. Wash the burner heads in the sink with mild
detergent and a plastic scrubber. For stubborn stains,
clean with Cooktop Cleaning Creme (Part #20000001).
S
Check to be sure all ports are open. To open clogged
ports, insert a straight pin directly into each port. Do not
enlarge or distort the port.
S
The aluminum burner base is not removeable. To
clean, wipe with a damp cloth.
S
When replacing the burner heads, carefully align the
tab on the burner base with the indentation in the head.
The two pins will fit in the slots when the tab is aligned
with the indentation.
NOTE: When burner heads are removed for cleaning, do
not spill liquids through the holes in the burner base.
BURNER HEAD
BURNER BASE
C – 4
AND HOW TO REMOVE RANGE
CLEANING AND
Follow these procedures to remove appliance for
cleaning or servicing:
1. Shut off gas supply to appliance.
2. Disconnect electrical supply to appliance, if equipped.
3. Disconnect gas supply tubing to appliance.
4. Slide range forward to disengage range from the
anti-tip bracket. (See page 5).
5. Reverse procedure to reinstall. If gas line has been
disconnected, check for gas leaks after reconnection.
NOTE:
reconnect the gas supply.
6. To prevent range from accidentally tipping, range must
be secured to the floor by sliding rear leveling leg into
the anti-tip bracket.
SERVICE-PARTS INFORMA
When your range requires service or replacement parts,
contact your dealer or authorized service agency. Please
give the complete model and serial numbers of the range
which is located on the range model number plate.
16026016
SERVICING
A qualified servicer should disconnect and
FOR
TION
©2005 Maytag Services