Cli: Viewing And Configuring Timep - HP ProCurve Series 4100GL Management And Configuration Manual

Time Protocols
TimeP: Viewing, Selecting, and Configuring
9-16
• Use the Space bar to select the
Press [>] to move the cursor to the
i.
ii. Enter the IP address of the TimeP server you want the switch to
use for time synchronization.
Note: This step replaces any previously configured TimeP server
IP address.
iii. Press [>] to move the cursor to the
6.
6. In the Poll Interval field, enter the time in minutes that you want for a TimeP
Poll Interval.
Press to return to the Actions line, then
[Enter]
time protocol configuration in both the startup-config and running-config
files.

CLI: Viewing and Configuring TimeP

CLI Commands Described in this Section
show timep
[no] timesync
ip timep
dhcp
manual
server <ip-addr>
interval
no ip timep
Manual
page 9-17
page 9-18 ff., 9-20
page 9-18
page 9-19
page 9-19
page 9-20
page 9-21
mode.
field.
Server Address
field, then go to step
Poll Interval
(for ) to enter the new
[S] Save