Cli: Viewing And Configuring Authorized Ip Managers; Listing The Switch's Current Authorized Ip Manager(S) - HP ProCurve 6200yl Series Access Security Manual

Using Authorized IP Managers
Defining Authorized Management Stations
Applies only to access through Telnet, SNMPv1,
and SNMPv2c. Refer to the note on page 12-3.
Figure 12-2. Example of How To Add an Authorized Manager Entry (Continued)
12-6
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag­
ers List screen (figure 12-1), highlight the desired entry, and press
or (for Delete).
[D]

CLI: Viewing and Configuring Authorized IP Managers

Authorized IP Managers Commands Used in This Section
Command
show ip authorized-managers
ip authorized-managers
<ip-address>
mask <mask-bits>
<operator | manager>

Listing the Switch's Current Authorized IP Manager(s)

Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
2. Enter an Authorized Manager IP address here.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
"Building IP Masks" on page 12-9.
4. Use the Space bar to select Manager or Operator
access.
5. Press [Enter], then [S] (for Save) to configure the
IP Authorized Manager entry.
Page
below
12-7
12-8
12-8
(for Edit)
[E]