Web: Viewing Port Status And Configuring Port Parameters - HP ProCurve Series 4100GL Management And Configuration Manual

Optimizing Traffic Flow with Port Controls, Port Trunking, and Port-Based Priority
These commands enable and configure port C8 from the config level:
■
HPswitch(config)# int e c8 enable
HPswitch(config)# int e c8 speed-duplex 100-full
HPswitch(config)# int e c8 flow-control
■ These commands select the context level for port C8 and then apply all
of the configuration commands to port C8:
HPswitch(config)# int e c8
HPswitch(eth-C8)# enable
HPswitch(eth-C8)# speed-duplex 100-full
HPswitch(eth-C8)# flow-control
Configuring a Broadcast Limit on the Switch. Executing this command
configures the broadcast limit for all ports on the switch.
Syntax:
broadcast-limit < 0 . . 99 >
For example, to configure a broadcast limit of 20% for all ports on the switch:
HPswitch(config)# broadcast-limit 20
To display the current broadcast limit setting, use one of the following com­
mands:
HPswitch# show config
Displays the startup-config file. The broadcast limit setting
appears here if configured and saved to the startup-config
file.
HPswitch# show running-config
Displays the running-config file.
Web: Viewing Port Status and Configuring Port
Parameters
In the web browser interface:
1. Click on the Configuration tab.
Click on Port Configuration.
2.
3. Select the ports you want to modify and click on Modify Selected Ports.
After you make the desired changes, click on Apply Settings.
4.
Note that the web browser interface displays an existing port trunk group.
However, to configure a port trunk group, you must use the CLI or the menu
interface. For more on this topic, see "Port Trunking" on page 10-10.
Viewing Port Status and Configuring Port Parameters
10-9