Interface Access
Enable/Disable
Console Control
Options
Figure 7-2. Listing of Show Console Command
CLI: Modifying the Interface Access
Interface Access Commands Used in This Section
show console
[no] telnet-server
[no] web-management
console
Listing the Current Console/Serial Link Configuration. This com
mand lists the current interface access parameter settings.
Syntax:
show console
This example shows the switch's default console/serial configuration.
Reconfigure Inbound Telnet Access. In the default configuration,
inbound Telnet access is enabled.
Syntax:
[no] telnet-server
To disable inbound Telnet access:
HPswitch(config)# no telnet-server
To re-enable inbound Telnet access:
HPswitch(config)# telnet-server
Interface Access, System Information, and Friendly Port Names
Interface Access: Console/Serial Link, Web, and Telnet
below
below
page 7-6
page 7-6
Event Log Event
Types To List
7-5