Using The Hp Toptools For Hubs & Switches Utility - HP ProCurve Series 4100GL Management And Configuration Manual

N o t e
For example, to download switch software from primary flash in a switch with
an IP address of 10.28.227.103 to the primary flash in the destination switch,
you would execute the following command in the destination switch's CLI:
Running Total
of Bytes
Downloaded
Figure A-5. Switch-To-Switch, from Primary in Source to Either Flash in
Destination
Downloading from Either Flash in the Source Switch to Either Flash
in the Destination Switch. This command (executed in the destination
switch) gives you the most options for downloading between switches.
copy tftp flash < ip-addr > < /os/primary > | < /os/secondary >
Syntax:
[primary | secondary]
If you do not specify either a primary or secondary flash location for the
destination, the download automatically goes to primary flash.
For example, to download switch software from secondary flash in a switch
with an IP address of 10.28.227.103 to the secondary flash in the destination
switch, you would execute the following command in the destination switch's
CLI:
Figure A-6. Switch-to-Switch, from Either Flash in Source to Either Flash in
Destination
Using the HP TopTools for Hubs & Switches Utility
HP TopTools for Hubs & Switches includes a software update utility for
updating on HP ProCurve switch products. For further information, refer to
the HP TopTools for Hubs & Switches User Guide, provided electronically
with the HP TopTools software.
Although TopTools recognizes the Switch 2626 as an SNMP device, custom­
ized device management is not supported for the Switch 2626 in HP TopTools
for hubs and switches.
File Transfers
Downloading Switch Software
A-11