Snmp Version 3 Commands - HP ProCurve Series 4100GL Management And Configuration Manual

C a u t i o n

SNMP Version 3 Commands

SNMP version 3 (SNMPv3) adds a new command to the CLI for configuring
SNMPv3 functions. To enable SMNPv3 operation on the switch you must:
a. Enable SNMPv3 with the snmpv3 enable command. An initial user
entry will be generated with MD5 authentication and DES privacy.
b. You may restrict access to only SNMPv3 agents with the snmpv3 only
command. A second option would be to restrict write access to only
SNMPv3 agents with the snmpv3 restricted-access command
Restricting access to only version 3 messages will make the community named
"public" inaccessible to network management applications (such as auto-
discovery, traffic monitoring, SNMP trap generation, and threshold setting)
from operating in the switch.
Syntax: [no] snmpv3 enable
Enable and disable the switch for access from SNMPv3
agents. This includes the creation of the a initial user record.
[no] snmpv3 only
Enables or disables restrictions to access from only SNMPv3
agents. When enabled the switch will reject all non SNMPv3
messages
[no] snmpv3 restricted-access
Enables or disables restrictions from all non- SNMPv3 agents
to read only access.
show snmpv3 enable
Displays the operating status of SNMPv3
show snmpv3 only
Displays status of message reception of non-SNMPv3
messages.
show snmpv3 restricted-access
Displays status of write messages of non-SNMPv3 messages.
Configuring for Network Management Applications
Using SNMP Tools To Manage the Switch
11-5