Status Messages - HP ProCurve Series 4100GL Management And Configuration Manual

HP ProCurve Stack Management
Configuring Stack Management
Message Condition
Candidate Auto-join Indicates a switch configured with Stack State set to
Candidate, Auto Join
Manager password.
Candidate Candidate cannot automatically join the stack because
one or both of the following conditions apply:
• Candidate has
• Candidate has a Manager password.
Commander Down Member has lost connectivity to its Commander.
Commander Up The Member has stacking connectivity with the
Commander.
Mismatch This may be a temporary condition while a Candidate is
trying to join a stack. If the Candidate does not join, then
stack configuration is inconsistent.
Member Down A Member has become detached from the stack. A
possible cause is an interruption to the link between the
Member and the Commander.
Member Up The Commander has stacking connectivity to the Member. None required.
Rejected The Candidate has failed to be added to the stack.
15-46

Status Messages

Stacking screens and listings display these status messages:
set to
Auto Join
Yes
(the default), and no
No
set to .
Action or Remedy
None required
Manually add the candidate to the
stack.
Check connectivity between the
Commander and the Member.
None required.
Initially, wait for an update. If condi­
tion persists, reconfigure the
Commander or the Member.
Check the connectivity between
the Commander and the Member.
The candidate may have a pass-
word. In this case, manually add
the candidate. Otherwise, the stack
may already be full. A stack can
hold up to 15 Members (plus the
Commander).