Cli: Configuring Rstp - HP ProCurve Series 4100GL Management And Configuration Manual

802.1w Rapid Spanning Tree Protocol (RSTP) and 802.1d Spanning Tree Protocol (STP)
Configuring Rapid Reconfiguration Spanning Tree (RSTP)
Spanning Tree Commands in This Section
show spanning-tree config
spanning-tree
protocol-version <rstp | stp>
force-version <rstp-operation | stp-compatible>
forward-delay <4 - 30>
hello-time <1 - 10>
maximum-age <6 - 40>
priority <0 - 15 | 0 - 65535>
<[ethernet] port-list>
path-cost <1 - 200 000 000>
priority <0 - 15 | 0 - 65535>
edge-port
point-to-point-mac
mcheck
mode <norm | fast>
show spanning-tree
14-10
5. Enable RSTP Spanning Tree:
CLI: spanning-tree
Menu: Main Menu —> 2. Switch Configuration —> 4. Spanning Tree
Operation —> select
STP Enabled: Yes

CLI: Configuring RSTP

Viewing the Current Spanning Tree Configuration. Even if spanning
tree is disabled (the default configuration), the show spanning-tree config
command lists the switch's full spanning tree configuration, including whole-
switch and per-port settings.
Syntax:
show spanning-tree configuration
Abbreviation:
Applicable Location
Protocol
Version
both Below on this page
both page 14-11
both page 14-12
RSTP page 14-12
both page 14-12
both page 14-12
both page 14-12
RSTP | STP page 14-12
both page 14-14
both page 14-14
RSTP | STP page 14-14
RSTP page 14-14
RSTP page 14-14
RSTP page 14-14
STP Refer to "802.1D Spanning-Tree Protocol (STP)"
on page 14-18.
This command lists additional RSTP/STP monitoring data that is
not covered in this section. See "Spanning Tree Protocol
Information" in appendix B, "Monitoring and Analyzing Switch
Operation"
sho span config