PRESONUS AudioBox Stereo Quick Start Manual page 364

o
Speed/Beats. Adjusts the speed of the phaser from 0.1 Hz to 30 Hz or
1/64T to 4 bars, respectively.
o
Mod Width. Adjusts the modulation width of the phaser from 0 to 100%.
o
Depth. Adjusts the relative depth of the phaser from 0 to 100%.
EQ
• Lead/Bass. Selects between two variations of seven-band graphic EQ.
• Lead. Adjusts frequency bands at 100, 200, 400, 800, 1.6k, 3.2k, and 6.4 kHz.
• Bass. Adjusts frequency bands at 50, 120, 400, 500, 800, 4.5k, and 10 kHz.
Distortion
• Type. Selects the type of distortion.
• Drive. Adjusts the drive of the distortion from 0% to 100%.
Pan
• Speed/Beats. Adjusts the speed of panning from 0.10 Hz to 30 Hz or 1/64T to 4
bars, respectively.
• Depth. Adjusts the relative depth of the pan from 0 to 100%.
Gate
• Pattern. Create a pattern by clicking on the 16 segments to open the gate for each
segment. The length of the pattern is adjusted with the Beats parameter, which is
then divided into these 16 equal segments.
o
Stereo. Enable this to create a stereo pattern.
• Beats. Adjusts the length of the gate pattern in beats, variable from 1/64T to 4
bars.
• Depth. Adjusts the relative depth of the gate from 0 to 100%.
Delay
• Send. Enable Send mode, where signal is fed into the delay as a send, rather than
inline as an insert.
• Beats. Adjusts the delay pattern in beats, variable from 1/64T to 4 bars.
• Feedback. Adjusts the feedback of the delay from 0% to 100%.
• Low Cut Filter. Adjusts the frequency of the low-cut filter from 20 Hz to 1 kHz.
246