Luggage Carrier - Invacare Bora XTR Series Service Manual

® ®
Invacare - Bora /Spectra
8.3

Luggage carrier

Requirements:
· 5 mm Allen wrench
· 10 mm open-ended wrench
· Loosen and remove both hexagon socket head screws (4) together with the washer. The
screws are located on the wheelchair.
· Install the luggage carrier fixation bracket (3).
· Install both hexagon socket head screws (4) together with the washers, spacer sleeve, etc.
· Repeat these work steps on the other side of the wheelchair.
· Open the clamping levers (5) of the luggage carrier fixation bracket.
· Push the brackets onto the luggage carrier (1).
· Install the luggage carrier with the brackets. When tightening the screws (2), make sure that the
luggage carrier is correctly centered.
· Close both of the clamping levers.
· Make sure that the luggage carrier does not collide with the backrest or seat when adjusting the
backrest angle or seat tilt to any setting.
· If collisions can occur:
- Open the clamping levers of the luggage carrier fixation bracket.
- Push the luggage carrier slightly towards the rear.
- Close the clamping levers of the luggage carrier fixation bracket.
®
XTR Series SERVICE MANUAL
123