Panasonic KX-TDA0480 Installation Manual page 106

Logical Installation
The port number can also be scrolled up and down with the scrolling arrows located to the right
of the field.
H.245 start port number
Type the number of the port on which the H.245 signalling will be initiated.
The default port number is 1721. From 4 to 65521 can be specified except FTP(20,21),
telnet(23) ports.
The port number can also be scrolled up and down with the scrolling arrows located to the right
of the field.
RTP start port number
Type the number of the port on which RTP/RTCP signalling will be initiated.
The default port number is 5004. From 4 to 65516 can be specified except SNMP(161),
RAS(1718,1719).
The port number can also be scrolled up and down with the scrolling arrows located to the right
of the field.
T.38 start port number
Type the number of the port on which T.38 signalling will be initiated.
The default port number is 5012. From 4 to 65521 can be specified except FTP(20,21),
telnet(23) ports.
The port number can also be scrolled up and down with the scrolling arrows located to the right
of the field.
UDP Port No. Supplementary service
A port used to transfer QSIG signals in an IP network when they are received, using the QSIG
connectionless supplementary service.
The default port number is 5003. From 4 to 65524 can be specified except FTP (20, 21), telnet
(23) ports.
When using this type of port, it will be necessary to unify it within the network.
The port number can also be scrolled up and down with the scrolling arrows located to the right
of the field.
Connect time to establish
Type the time (seconds) that will be allowed for call signalling to be established.
The range of acceptable values include from 1 to 99 seconds. The default value is 30 seconds.
The Time value can also be scrolled up and down with the scrolling arrows located to the right
of the field.
Restore defaults
Click on the Restore defaults button to return the values for all fields to their default condition.
106 Installation Manual