User Mode - SATO GL4 Series Operator's Manual

Section 3: Configuration and Operation

3.4 USER MODE

The following settings are available in User Mode:
DISPLAY SUB-MENU RANGE
Print Speed
Print Darkness
Pitch Offset
Vert Print Offset
Hor Print Offset
Label Length
Label Width
Slash Zero
Character Pitch
Protocol C. Code
Euro Character
Ver BaseRefPoint
Hor BaseRefPoint
Mem Select (CC1)
Orientation
Units
Page 3-4
DEFAULT
2 to 10 (50.8 - 254.0 4 ips (101.6 mm/
mm/sec) sec)
-15 to 15 5
-0.50 to 0.20 (-12.7 to 0.00 mm
5.1 mm)
-1.00 to 12.80 (-25.4 0.00 mm
to 152.0 mm)
-1.00 to 1.00 (-25.4 to 0.00 mm
25.4 mm)
00.1 to 99.0 (3 to 2514 152 mm)
mm)
00.1 to 04.1 (3 to 104 104 mm)
mm)
Disable/Enable Disable
Proportional/Fixed Proportional
Standard/ Non- Standard
Standard
0 to 255 213
-9999 to 9999 0
-9999 to 9999 0
Card/Memory Card
Portrait Portrait/Land-
scape
Inches/Millimeters Millimeters
DESCRIPTION
Selects the printing speed.
Lower speeds usually yield bet-
ter print quality. Settings avail-
able are dependent on print
head resolution.
Selects the print darkness. Do
not increase print darkness to
compensate for poor print head
condition or maintenance.
See pg 3-5
See pg 3-6
See pg 3-6
Sets the length of each label in
the label roll to be used
Sets the width of the label roll to
be used
Selects whether the character
"0" has a diagonal slash across
it, to differentiate it from the let-
ter "O"
Selects whether the spacing
between every character is fixed
(Fixed) or variable (Propor-
tional) in accordance to charac-
ter width.
See pg 3-6
Selects the character to repre-
sent the Euro currency
See pg 3-7
See pg 3-7
Selects the default storage
memory to be the optional
memory cartridge or standard
printer memory
Selects the print orientation
Selects the default unit of mea-
surement in menus
GL Series Operator's Manual