SATO GL4 Series Operator's Manual page 41

Job Control
Offline Process
WLAN Address IP Address
xxx.xxx.xxx.xxx
Subnet Mask
xxx.xxx.xxx.xxx
Gateway
Address
xxx.xxx.xxx.xxx
MAC Address
xxx.xxx.xxx.xxx
DHCP
WLAN Setting Signal Strength
Operation Mode Infrastructure/Pseudo
SSID Name
Reset SSID
Name
Min.Xfer Rate
Channel
Ant.Diversity
Preamble
Power Mgmt
GL Series Operator's Manual
Off/Standard/ Standard
Enhanced
Disable/Enable Disable
Per TCP/IP standard 000.000.000.000
valid address range
Per TCP/IP standard 000.000.000.000
valid address range
Per TCP/IP standard 000.000.000.000
valid address range
Per TCP/IP standard Read-only,
valid address range uniquely assigned
Disable/Enable Disable
NA NA, read-only
Infrastructure
IBSS/Ad Hoc
1 to 32-character, NA
case sensitive string
including alphanumer-
ics, symbols and
spaces
NA NA
Auto-negotiate/1 Mb/ Auto-negotiate
sec./2 Mb/sec./5.5 Mb/
sec./11 Mb/sec.
Default/1-15 Default
Diverse/Primary/Auxil- Diverse
iary
Default/Short/Long Default
0 to 1000 ms 0 ms
Section 3: Configuration and Operation
Appears only if LAN interface is
selected. Standard: NIC waits for entire
job to be received before indicating that
a job is done. Enhanced: Waits for
entire job to be printed before a similar
indication.
Appears only if LAN interface is
selected
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected. Consult your administrator for
the appropriate setting.
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected. An Access Point is needed
for Infrastructure Mode. Pseudo IBSS
requires two peers specific to the same
manufacturer, running standard Peer-
to-Peer communication without an
Access Point. Ad Hoc mode achieves
standard Peer-to-Peer communication
without an Access Point and the two
peers can be from different manufac-
turers.
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected. Selects the RF channel.
Appears only if WLAN interface is
selected. Select Primary or Secondary
to use the relevant antenna on the
server.
Appears only if WLAN interface is
selected
Appears only if WLAN interface is
selected. Sets the sleep time for power
saving.
Page 3-9