SATO GL4 Series Operator's Manual page 7

1.1 GENERAL SPECIFICATIONS (CONT'D)
Specification/
Model Name
Print method
Head density
Print valid range (width)
Print speed
Paper Thickness
Standard
Label size
(mounting
Tear off
and
cardboard
size)
Peel
Cutter
Non-
separate
Number of Roll paper
loadable
sheets
Fanfold
paper
Carbon ribbon
Width
Length
Thickness of base material
Color
Winding direction
Internal Memory
Label dispensing modes
Dimensions
Weight
Power supply
Operating Environment
GL Series Operator's Manual
GL408e
8 dots/ mm (203 dpi)
Not printable for 3 mm from the rear edge
2,3,4 (Default),5,6,7,8,9,10 inches/sec
Note:
Maximum speed may be further dependent on the type of print layout, paper,
or carbon ribbon in use.
0.060 mm to 0.268 mm supported.
Note:
Be sure to use only printer supplies manufactured or certified by SATO.
Width: 22 to 128 mm (25 to 131 mm)
Pitch: 6 to 397 mm (9 to 400 mm)
Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Width: 22 to 128 mm (25 to 131 mm)
Pitch: 17 to 397 mm (20 to 400 mm)
Maximum external diameter:
265 mm (Approximately 150 m/roll, 3-inch paper tube used) or 230 mm for 1.5" or 4" cores
Back winding (only front winding for linerless mode)
Maximum folded height: 200 mm
See the section in this manual on Setting Fanfold Paper
Be sure to use the specified carbon ribbon manufactured by SATO.
39.5, 45, 59, 76, 84, 92, 102, 111, and 128 mm
Use a carbon ribbon that is wider than the paper used (450 m/roll max)
4.5 µm (for 450mm maximum roll length)
Black (standard), other colors also available
Front winding and back winding
8MB Flash, 32MB DRAM, with additional 1.426 MB interface buffer
Continuous, tear off, peeler, dispenser and non-separate
W 271 mm x D 455 mm x H 305 mm x (Standard)
15 kg (for a standard configuration)
Input voltage: AC 100 V to 240 V ±10%
Power consumption: Maximum 200 VA 150 W, print rate 30% (89 VA 40 W on standby)
Operational ambient temperature: 0 to 40 ×C
Operational ambient humidity: 10 to 90% (without condensation)
Storing ambient temperature: -5 to 60 ×C
Storing ambient humidity: 10 to 90% (no condensation)
(Paper, and carbon ribbon excluded)
Thermal transfer or direct thermal
12 dots/ mm (305 dpi)
104 mm x pitch 2514 mm
Section 1: Introduction
GL412e
Note:
Supported sizes may
be regulated due to
the quantity of print
jobs or size of paper.
Other usage condi-
tions may restrict the
range of label sizes
supported.
Page 1-3