Adjusting The Paper Sensor - SATO GL4 Series Operator's Manual

2.3 LOADING LABELS AND TAGS (CONT'D)

2.3.4 Adjusting the Paper Sensor

Adjustment of the paper sensor is usually not necessary, but the procedure is described here.
1. Lift up the cover. Make sure that the cover rests firmly
on the top of the printer so that it will not fall forward
and injure your hands.
2. The purple sensor unit is located just above the label
damper assembly. (the black plastic label path
stabilizer has been removed in the picture). Slide the
sensor outwards to adjust its position. Remember to
replace the label path stabilizer after the adjustment.
3. You can continue to load media by following the steps
in previous sections, or close the front cover.
Caution
• When closing the printer cover, be careful not to injure your fingers due to a sudden release of the heavy cover.
GL Series Operator's Manual
Lift up the
cover
Paper sensor
Section 2: Installation
Page 2-17