SATO GL4 Series Operator's Manual page 52

Section 3: Configuration and Operation
*Batch Counter
Disp. Intensity
*SENSOR SETUP Sensed Distance
Gap/Mark Thresh
Run Manual Cal
Pwr Up Auto-Cal
Head Auto-Cal
Online Auto-Cal
Gap Windowing
Gap Length
Cal in Peel Mode
Min Calib Delta
Use Label Length
Threshold Range
Admin User
Page 3-20
Disable/Enable
Enable (factory default): The #
Pages remaining to be printed will
display on the second line of the
control panel LCD. This feature is
supported in PGL and ZGL only.
The PGL Execute command to sup-
port this feature is
~EXECUTE;NAME;(#Pages). The
ZGL Execute command is
^PQ(#Pages).
0 to 20
1 to 9.9 (0.1 to 251.5 mm)
0 to 255
Enable/Disable
Enable/Disable
Disable/Enable
Disable/Enable
0.05 to 1.00 (2 to 25 mm)
Disable/Enable
012 to 050
Disable/Enable
5 to 95%
Disable/Enable
Displays the number of pages
Disable
remaining in a print job.
Disable: The # Pages remain-
NOTE: If the correct execute
ing to be printed will not dis-
command is absent from the
play. Instead, the Active
print file, "0 Pages" will continu-
emulation and interface will
ally display on the control panel
display on the second line of
LCD.
the control panel LCD.
Sets the Display Intensity val-
10
ues from 0 to 20.
0 inches (00.0 mm)
140
Enable
Enable
Disable
Disable
0.12 inches (3 mm)
Disable
20
Disable
50%
When enabled, this function
Disable
permits access to submenu
items not normally accessible
to a typical user.
GL Series Operator's Manual