Plu Programmed Data Copying - TEC MA-1595-1 SERIES Owner's Manual

6. PROGRAMMING OPERATIONS
6.6.3

PLU Programmed Data Copying

This operation is used to copy the programmed data of a PLU item and to use it in programming another PLU
item, thus eliminating time in PLU programming operation.
CONDITION
To program new PLUs or to change any programmed contents of PLUs:
OPERATION To change the PLU of the copy-destination with sales data not zero:
4 [X] |PLU Code of the copy-destination| [PLU]
Example) To program PLU 90701 (Drink Small-B) again that was once programmed and then deleted, by
copying the programmed data of PLU 90601 (Drink Small-A):
Key Operation Mode Lock: SET, enter 4, depress the [X] key.
90701 [PLU] (PLU Code of the copy-destination)
[NS]
90601 [PLU] (PLU Code of the copy-source)
2 [ST] (Address 2, Name changed into: Drink Small-A)
404 [#] (D)
702 [#] (r)
609 [#] (i)
614 [#] (n)
611 [#] (k)
[#] (Space)
503 [#] (S)
613 [#] (m)
601 [#] (a)
612 [#] (l)
612 [#] (l)
213 [#] (-)
402 [#] (B)
[ST]
9 [ST] 7 [#] (Address 9, PLU Group No. changed into: 7)
[AT/TL] (to complete this submode)
Any time outside a sale (except the following case)
After PLU Reset
|PLU Code of the copy-source| [PLU]
The programmed data of the copy-source PLU is now copied to the copy-destination
PLU (except the PLU Code). Then follow the procedure in Section 6.6.1
Programming or Changing to change data of any required Addresses.
6-22
6.6 PLU Table Programming (Submode 4)
[NS]
7(& 6725( 7(& 6725(
 3($&+ '5,9(
3+21( 
2SHQ  DP WR  SP
&ORVHG HYHU\ :HGQHVGD\
 )5, 
3 3
 
'ULQN 6PDOO$
  
 'ULQN 6PDOO%



   70
EO1-11152